Dish Rack

https://www.thingiverse.com/thing:2514576

Dish Strainer – Plates Rack by Jeramie Lim

Printed very quickly at low resolution, 0.32mm layer height with a 0.8mm print core, it took 3 hours. I ran out of green plastic filament so I switched to using my leftover grey PLA, leaving the topmost layers a different colour. My 3d printer (Ultimaker S5) automatically pauses when it runs out of filament and prompts you to swap to a new one.

3d prints

Basketball Bin

3d prints

Makeup Organisers

The light, marble-coloured makeup bridge can be downloaded here thanks to designer Sebastian Porombka. The black powderbox organiser by Rico Hauptmann can be downloaded here.

3d prints

Hair dryer holder

I printed this GHD hairdryer bracket by David Boyle in black PLA at 0.2mm layer height, and secured it to my dressing table with 3M mounting tape.

3d prints

Command hooks

These are much deeper than authentic command hooks. To mount them, I use the extra adhesive strips that come with a pack of hooks. The model was designed by user […]

3d prints

Sunglasses rack

3d prints

Nespresso Capsule Holder

Printed in four parts in grey PLA for less than a dollar worth of material and three hours in printing time at 0.2mm layer height. Designed by Cynthia Ryskamp-Curler available […]

3d prints

Doll Coat Hangers

These tiny clothes hangers took just 2 minutes each to print, for a couple of cents worth of material. They were printed in yellow or grey PLA at 0.2mm layer […]

3d prints

PRINTING.LIFE

Dish Rack

Basketball Bin

Makeup Organisers

Hair dryer holder

Command hooks

Sunglasses rack

Nespresso Capsule Holder

Doll Coat Hangers

Nintendo 64 Games Stacker